Previous, Next, Contents, Home.

Control Unit Inputs

The circuit information in Table j is used to make measurements at the CIS-E Motronic control unit connector, checking the components and the wiring harness which supply input signals to the control unit. As a general rule, a complete absence of the voltage or continuity specified in the table suggests an open circuit in the wiring harness. For more specific information, see CURRENT FLOW DIAGRAMS.

Test results which differ from the value specified in the table do not necessarily indicate a faulty component. Check for loose connections or connections which are inadequate due to contamination or corrosion.

CAUTION-

Use only a high input impedance voltmeter, ohmmeter, or multimeter. The electrical characteristics of other types of test equipment may cause inaccurate results or damage to the electronic components. For more information, see FUNDAMENTALS.

Use care to avoid damaging the delicate connector terminals with meter probes during testing. For best and safest results, fabricate a set of test leads as shown in Fig. 6-49. Use the flat connectors (Volkswagen part no. N 17 457 2 or equivalent) to make contact with female connector terminals, then connect the meter leads to the insulated alligator clips.

Before performing the tests indicated by the table, disconnect the coil wire from the center tower of the distributor cap and connect it to ground on the engine block with a jumper wire. With the ignition turned off, disconnect the 35-point connector from the Motronic control unit and test as indicated in Table j. The control unit is located in the upper left (driver's) side of the engine compartment, beneath the drip tray. The drip tray is clipped into place. Pull it up carefully to remove it for access to the control unit.

CAUTION-

Always connect or disconnect the control unit connector and the meter probes with the ignition off, to avoid damage to the electronic components.

Fig. 6-49. Test leads made with flat connectors (Volkswagen part no. N 17 457 2 or equivalent) and alligator clips, used to make contact without connector damage.

Table j. CIS-E Motronic Electrical Tests

Previous, Next, Contents, Home.